Item #969447

Victron Energy Phoenix Smart IP43 Charger

51 Review
$371.45 - $523.95
                          Want an email once available?
                          Buy with

                          Image of : Victron Energy Phoenix Smart IP43 Charger Victron Energy Phoenix Smart IP43 Charger Item # 969447

                          Description

                          With boat owners in mind, this adaptive 5-step charger can provide a charge to battery banks. Bluetooth enabled, you can monitor the charger and set alarms straight from your phone.

                          Features:

                          • Bluetooth Smart built-in - set up, monitor, update and synchronize Phoenix Smart IP43 Chargers
                          • Phoenix Smart (1+1): two outputs to charge 2 battery banks - the second output, limited to approximately 4A and with a slightly lower output voltage, is intended to top up a starter battery
                          • Phoenix Smart (3): three full current outputs to charge 3 battery banks - each output can supply the full rated output current
                          • Compensates for voltage drop over the DC cabling by slightly increasing output voltage when the DC current increases
                          • Adaptive 6-stage charge algorithm: bulk - absorption - recondition - float - storage - refresh
                            • 'Adaptive' battery management system can be preset to suit different types of batteries
                            • Automatically optimizes the charging process relative to the way the battery is being used
                          • BatterySafe mode - the charger will prevent damage due to excessive gassing by automatically limiting the rate of voltage increase once the gassing voltage has been reached
                          • Storage Mode kicks in whenever the battery has not been subjected to discharge for 24 hours
                            • In the Storage Mode, float voltage is reduced to 2.2V/cell (13.2V for a 12V battery) to minimize gassing and corrosion of the positive plates
                            • Once a week the voltage is raised back to the absorption level to 'equalize' the battery
                          • Charges Li-ion (LiFePO4) batteries by connecting a relay or open collector optocoupler output from a Li-ion BMS to the remote on-off port
                          • Fully programmable charge algorithm
                          • A Smart Battery Sense or a BMV-712 Smart Battery Monitor can be used to communicate battery voltage and temperature to one or more Phoenix Smart IP43 Chargers
                          • Remote on-off switch or relay contact can be connected between H and L - alternatively, terminal H can be pulled high, or terminal L can be pulled low
                          • VE.Direct interface for a wired data connection to a Color Control panel, PC, or other devices
                          • May be programmed using the VE.Direct interface or a Bluetooth-enabled device to trip on an alarm or other events
                          • Pair two or more Phoenix Smart IP43 Chargers in a VE.Smart Network to improve the charge efficiency and battery life

                          Note: Requires 5-15P mains cord

                          Datasheet

                          Part Numbers for Victron Energy Phoenix Smart IP43 Charger

                          Related Categories

                          Related Categories

                          Reviews

                          • bvseo_sdk, p_sdk, 3.2.1
                          • CLOUD, getReviews, 36.72ms
                          • REVIEWS, PRODUCT
                          • bvseo-msg: HTTP status code of 404 was returned;

                          Questions

                          • bvseo_sdk, p_sdk, 3.2.1
                          • CLOUD, getContent, 93.55ms
                          • QUESTIONS, PRODUCT
                          • bvseo-msg: HTTP status code of 404 was returned;