Sea Hawk Tuff Stuff High-Build Epoxy Primer Kit
$68.73 - $185.71
$68.73 - $185.71
15% off

Sea Hawk Tuff Stuff High-Build Epoxy Primer Kit
Item # 881400
Description
The Sea Hawk Tuff Stuff High-Build Epoxy Primer Kit provides premium blister protection with micro sheet silicate technology. It is a high-build, two-part epoxy primer that dries fast, enabling application of a complete barrier system and bottom paint in just two days.
Features:
- Premium blister protection with micro sheet silicate technology
- High-build, two-part epoxy primer - requires fewer coats
- Dries fast, enabling application of a complete barrier system and bottom paint in just two days
- Using micro sheet silicate technology, millions of microscopic sheets overlap and build a 100% water barrier that eliminates any direct path for water migration from moisture and water penetration
- Extremely effective for blister prevention on fiberglass, or as a bilge coating, because it is resistant to oil and water
- Protects metals from corrosion, including: aluminum, bronze, stainless steel, cast iron and lead above and below the waterline
- Excellent for priming props, shafts, keels, trim tabs, thru hulls and lower units
- It can be applied at 10-15 mils wet film in one coat, using a brush, roller, airless or conventional spray
- Fills deep scratches and gouges in a few coats and can be sanded within 8 hours to a smooth finish
- Available in light gray and white
- Use over blistered fiberglass as a repair coat, and over un-blistered fiberglass as a barrier coat
Specifications:
- Type: High-build, 2-part epoxy primer
- Colors: White or light gray
- Finish/sheen: Matte
- Volume solids: 52% +\- 2%
- Size: 1-Gallon kit (2 half-gallons) or 1-Quart kit (2 pints)
- Mix ratio: 1:1
- Induction time: 20 - 30 minutes
- Pot life: 3 hours
- Flash point: 80° F
- VOC: 444 grams/liter
- Typical film thickness:
- Dry: 6 - 7.5 mils per coat
- Wet: 11.5 - 14.5 mils per coat
- Recommended coats: 2 - 4 depending on intended service
- Theoretical coverage: 140 sq. ft./ Gal. @ 6.0 mils DFT
- Induction time: 20-30 minutes
- Application: Brush, roller, conventional sprayer, airless sprayer
- Solvent resistant roller cover: 3/8"- 3/16" pile nap (smooth to medium)
- Dry times and overcoating intervals:
- Substrate temp/Touch dry/Recoating/Overcoating with bottom paint
- 73°F (23°C)/2 hours/3 hours/6 days/24 hours
- Substrate temp/Touch dry/Recoating/Overcoating with bottom paint
- Thinning and cleaning: Sea Hawk 2044