Sea Hawk Low VOC Tuff Stuff High-Build Epoxy Primer Kit

The Sea Hawk Low VOC Tuff Stuff High-Build Epoxy Primer Kit provides premium blister protection with micro sheet silicate technology. It is a high-build, two-part epoxy primer that dries fast, enabling application of a complete barrier system and bottom paint in just two days.

Features:

• Premium blister protection with micro sheet silicate technology
• Highest build two-part epoxy primer that dries fast, enabling application of a complete barrier system and bottom paint in just two days
• Using micro sheet silicate technology, millions of microscopic sheets overlap and build a 100% water barrier that protects the surface from moisture and water penetration
• Extremely effective for blister prevention on fiberglass, or as a bilge coating, because it is resistant to oil and water
• As a universal primer, it can be used for corrosion protection on most metals below the waterline, and for priming any metal
• It can be applied at 10-15 mils wet film in one coat, using a brush, roller, airless or conventional spray
• Fills deep scratches and gouges in a few coats and can be sanded within 8 hours to a smooth finish
• Available in light gray and white
• Use over blistered fiberglass as a repair coat, and over un-blistered fiberglass as a barrier coat
• Protects metals from corrosion, including: aluminum, bronze, stainless steel, cast iron and lead
• Excellent for priming props, shafts, keels, trim tabs, thru hulls and lower units
• Suitable for above and below the waterline

Specifications:

• Type: High-build, 2-part epoxy primer
• Colors: Light gray or white
• Finish/Sheen: Matte
• Volume Solids: 52% +\- 2%
• Size: 1-Gallon kit (2 half-gallons)
• Mix Ratio: 1:1
• Induction Time: 20-30 minutes
• Flash Point: 80° F
• VOC: 280 g/L
• Typical film thickness:
  • Dry: 6 - 7.5 mils per coat
  • Wet: 11.5 - 14.5 mils per coat
• Recommended Coats: 2-4 depending on intended service
• Theoretical Coverage: 140 sq. ft./ Gal. @ 6.0 mils DFT
• Induction Time: 20 - 30 Minutes
• Pot Life: 3 hours
• Solvent Resistant Roller Cover: 3/8"- 3/16" pile nap (smooth to medium)
• Dry times and overcoating intervals:
  • Substrate temp / Touch dry / Recoating / Overcoating with bottom paint
    • 73°F (23°C) / 2 hours / 3 hours / 6 days / 24 hours
• Thinning and Cleaning: Sea Hawk 2044

Data Sheet

Application Guide