Nauta Heavy Duty Holding/Diesel Fuel Tank

The Nauta model tank can be used as a Holding tank or Diesel Fuel tank. This tank is not intended for use with gasoline. There are no fittings included with this tank. Fittings are required and can be purchased separately. The size and type of fittings should be determined by your use of the tank. You can purchase, locate and install the fittings according to your needs. A spanner wrench (FTP010) is included with this tank and is designed for fitting installation, removal and relocation.

Diesel Fuel Storage Tank: NAUTA® flexible diesel tanks can dramatically extend the range of powered sail and motor boats. They can be deck or cockpit mounted to gravity feed (or be hand-pumped) to tankage below decks. And, when empty, these tanks can be rolled up and stowed. Sport and commercial fishermen heading into offshore waters and cruisers visiting remote ports (where refueling may be unavailable or of suspect quality) will find these NAUTA® tanks an ideal, low cost solution.

Waste Storage Holding Tank: The more rigorously enforced laws against overboard discharge now make non-compliance extremely costly. A NAUTA® flexible holding tank, on the other hand, provides a relatively inexpensive Type III solution. In addition, the Teldar™ lining of these NAUTA® tanks prevents gas permeation, thus stopping a major odor problem associated with many other holding tanks. Combined with a few other components, this solution is both legal and far less costly than re-plumbing a vessel or installing a more complex and expensive Type I or Type II system. These tanks occupy less space and requires no electrical power. 1 Year warranty coverage

Nauta model FT915150 Specifications:

• Stated capacities are given for optimum expanding conditions (a flexible tank conforms to and is limited by the space in which it is mounted)
• Flat Dimensions:
  • Dimensions are for empty tanks
  • When the tanks are mounted horizontally and filled, these dimensions reduce by 10% to 15%
  • The filled depth (highest to lowest point) ranges from 12" to 16", depending on tank size
• Tank Material: 935-Dtex nylon fabric
  • Coated on both sides with a neoprene / nitrile compound
• The size and type of fittings should be determined by your use of the tank
• You can purchase, locate and install the fittings according to your needs
• The Factory installed Center Cleanout Fitting with Threaded Cap does not accept any standard fittings
• A spanner wrench (FTP010) is included with this tank and is designed for fitting installation, removal and relocation

General Nauta Tank Features:

• Each Nauta tank uses an extremely rugged 935-dtex nylon fabric
• Coated on both sides with a neoprene / nitrile compound
• Heavily lapped seams are inside-reinforced with a "doubler" to provide extra strength
• All NAUTA® tanks are vulcanized to assure leak proof panels and seams for years of trouble-free service
• Because of their flexibility, these tanks can fit into almost any space, especially those odd-shaped places that would otherwise be wasted
• NAUTA® tanks are very easy to work with
• Some tanks used for water and holding are available with fittings already installed
• NAUTA®'s construction also allows custom placement of fittings to suit your particular requirements and makes it simple to install them
• All are covered by warranty

Note: This model does not include required fittings (Fittings can be Purchased Separately)