Jabsco Original Brass Hand Pump - 33745-0000

Features:

• J absco Utility Hand Pumps pump more liquid with less effort
• They never need coaxing or priming and give full suction on the first stroke
• Pumps can be used in any position
• Applications: Bilge pumping, oil draining, diesel fuel transfer, and many other liquid transfer applications
• Jabsco Utility Hand Pumps use long life brass cylinders, high-quality oil resistant plungers, intake and discharge caps

Note: Oil temperature should not exceed 140° F

Explosion hazard. Do not pump gasoline, solvents, thinners or other flammable liquids. To do so can cause an explosion resulting in injury or death.

Specifications:

• Strokes per Gallon: 7
• Cylinder Diameter: 1-3/4"
• Stroke Length: 14"
• Overall Length: 22-1/2"
• Hose Connection: 1"
• Weight: 4.0

Maintenance

• To disassemble pump for cleaning and repair, pull handle out approximately 4" and place screwdriver carefully under bottom of spout cap and over outside of cylinder roll
• Lift up on screwdriver and pry off spout cap. Pull out plunger shaft assembly
• Lift full floating plunger off seat and clean between cup and seat
• Remove intake cap in same way as spout cap
• Take disc valve from cylinder and clean under neoprene flapper
• Run rag through cylinder for cleaning
• To reassemble pump, place disc valve in cylinder, snap intake cap back onto cylinder being sure undercut in cap is over cylinder roll
• Insert plunger shaft assembly into cylinder and snap spout cap over cylinder roll
• Oil pump internally and coat exterior of brass cylinder with corrosion inhibitor or light oil for storage.