Isotherm 2012 Compact Classic Air Cooled Refrigeration Component System - U170X056P12111AA
$1,058.00
Isotherm 2012 Compact Classic Air Cooled Refrigeration Component System - U170X056P12111AA Item # 870760
Description
The Isotherm Compact Classic Model 2012 is an air cooled refrigeration system that can cool as a refrigerator or as a freezer. The maximum freezer capacity is 2 cu.ft. and the maximum refrigerator capacity is 6 cu.ft.. It's a fan-cooled compressor unit designed for simple installation in existing top or side-loaded refrigerator boxes. All Isotherm Compact Systems come complete and pre-charged. Each system is rated to refrigerate or freeze a specific volume so there's no guessing what will work best for your boat.
Features:
- Refrigerator or freezer use
- Fan-air cooled compressor, electronics and refrigerant
- 12 / 24V DC Danfoss compressor
- To simplify the installation, the system is split into two sections:
- Compressor/condenser unit
- Evaporator
- Easy to install with pre-charged system, "Click-on" bracket and quick connect lines
- Compact footprint, no special plumbing required - can mount on deck or bulkhead
- Be sure to mount air-cooled compressors in a location that will not trap heat in a closed compartment or in an area will get hot (such as an engine room)
- It is important that the compressor compartment is well ventilated allowing cool air to enter from below and hot air to escape at the top
- To archive good operating results, the following is essential:
- Use polyurethane or similar foam
- 30 mm (1-1/4") thick for 50 liter (1.8 cu.ft.) boxes
- 50 mm (2") for boxes up to 80 liter (2.8 cu.ft.) boxes
- 100 mm (4") or more for larger boxes
- Battery capacity should be at least of 75 Ah to enable sufficient power to be stored during engine operation
- All the electrical power supply equipment such as alternator, regulator, cables, connectors and batteries must be kept in good condition
- Use polyurethane or similar foam
Specifications:
- Maximum Box Volume: 6 cu. ft
- Type: 2012
- Evaporator: Flat
- Dimensions:
- Evaporator: 32" x 8"
- Compressor: 12" x 6" x 6"
- Power Draw (Max.A): 4.5A @ 12V
- Weight: 32 lbs
- Danfoss Compressor Model: BD50
Notes:
- Maximum freezer capacity of 2 cu.ft. and maximum refrigerator capacity of 6 cu.in.
- The Isotherm warranty is 2 years from the date of purchase on all components and a 5 year limited warranty on the compressor
Part Numbers for Isotherm 2012 Compact Classic Air Cooled Refrigeration Component System - U170X056P12111AA
Reviews
Rated 5 out of
5
by
Torsten from
Does the trick
Easy install, the evaporator can be bent. About 3A roughly half of the time when being used in average conditions. Compressor installed under cockpit seat, no noise inside the cabin.
Date published: 2024-04-09
Questions
Can you bend the evaporator plate?
Absolutely. It comes with a bending tool and instructions and is easy to do. No problems. The most important thing is to not bend where one refrigerant line doubles (forks) into two lines.
Date published: 2024-04-09