Garmin Boat Switch - 010-02735-00

Get the integrated-boat experience with digital switching that allows you to operate onboard electrical functions right from your GPSMAP® or ECHOMAP™ chartplotter.

Features:

• Replace existing two-element systems - fuse box and switches - for easier control and operation of onboard functions
• Get control and protection of up to 20 circuits via your chartplotter rather than a physical button or switch
• The toggle outputs operate bilge pump and nondimmable lights, such as nav lights and courtesy lights
• Press-and-hold dimmers let you set your preferred brightness on board
• Control horns and more - simply press and release for desired length of horn beep
• A built-in timer turns the pump to cycle the water to keep fish alive - and keep pumps functioning longer
• Experience built-in tank sender detection and calibration for as many as four tanks, such as fuel, freshwater, graywater, blackwater and livewell
• See analog voltages on house and start battery, monitor bilge pump operation, and connect optional physical switches
• Retrofit into existing boats without special tools or configuration by using the included 18" flying leads and color-coded channel wires

Specifications:

• Dimensions (W x H x D): 9.1" x 4.2" x 1.5" (230 x 106 x 38 mm)
• Weight: 14.1 oz (400 g)
• Ambient temperature: -20° C to +55° C
• Enclosure water rating: IP65
• Communication: CAN-bus NMEA 2000® network, LEN-0
• High side: 13 ch 10A, 7 ch 5A
• Ground contact switch input: 15
• Bilge pump monitor: 2
• Volt: 3 @ 0-16 V +/-1%
• Resistance: 2 @ 0-1500 ohm +/- 5%
• Maximum current: 50A
• Power off current consumption: 60mA
• Supply voltage (12V): 9-16V DC
• NMEA 2000®: Micro 5-pin M12 male
• Channels: Molex MX150 L 16 circuits
• Power terminal: M6 bolt

Included:

• Garmin Boat Switch
• Garmin Boat Switch harness X1
• Garmin Boat Switch harness X2
• Installation instructions

Installation Instructions