Oceanic Systems J1939 to NMEA2000 Adaptor - 3185

The Oceanic Systems' 3185 J1939 to NMEA2000® Adaptor takes standard J1939 engine and transmission messages and transmits them onto the NMEA2000® network, playing an important part in their NMEA2000-based Vessel Moitoring and Control Systems.

Features:

• WAGO terminals for J1939 connection
• J1939 interface optically isolated to prevent ground loop problems
• J1939 interface is Read Only, so no messages are sent to the J1939 interface for absolute safety
• Switch selectable J1939 Source -Requires NO user setup menus but the simple setting of two small rotary source and address switches alllows multiple Adaptors to exist on the same network
• J1939 Valid Message LED indicates when J1939 messages are received and when NMEA2000® messages are transmitted
• Switch settable NMEA Device Instance
• Panel or DIN rail mounting - The J1939 connections to the unit are made via boat builder preferred WAGO Cage Clamp terminal blocks which allow either solid or multistranded wires from 0.08 to 1.5mm² to be connected quickly and securely
• Low Cost
• Certified to NMEA2000®

Specifications:

• NMEA2000® Level B
• Maritime Navigation and Radiocommunication Equipment: IEC 60945, IEC61000-4-2,4 and 5
• CE and FCC: Electromagnetic Compatibility
• Operating Voltage: 9 - 16V DC
• Power Consumption: 120mA at 12V
• Load Equivalence Number: 3
• Reverse Battery Protection: Indefinitely
• Load Dump Protection: Yes to SAE J1113
• Size: 125 x 78 x 35mm
• Weight: 120 gms
• IEC 60945 Classification: Protected
• Protection: IP40
• Operating Temperature: -25C to +50C
• Storage Temperature: -40C to +70C
• Relative Humidity: 93%[email protected] per IEC60945-8.2
• Electromagnetic Emission: Conduct/Radiated per IEC 60945-9
• Electromagnetic Immunity: Conducted/Radiated per IEC 60945-10, 61000

Product Manual

Data Sheet